Cub Cadet 54-inch Betreibershandbuch PDF herunterladen (Seite 10)

10 Section 2— ASSembly & Set-Up

Connecting the Battery Cables

CALIFORNIA PROPOSITION 65 WARNING!



contain lead and lead compounds, chemicals known

to the State of California to cause cancer and

reproductive harm. Wash hands after handling.

CAUTION: When attaching battery cables, always





For shipping reasons, both battery cables on your equipment

may have been left disconnected from the terminals at the

factory. To connect the battery cables, proceed as follows:

NOTE: The positive battery terminal is marked Pos. (+). The

negative battery terminal is marked Neg. (–).

NOTE: If the positive battery cable is already attached, skip ahead

to step 2.

 Remove the plastic cover, if present, from the positive

battery terminal and attach the red cable to the positive



Figure 1-6

2. Remove the plastic cover, if present, from the negative

battery terminal and attach the black cable to the negative

battery terminal (–) with the bolt and hex nut. See Figure



 Position the red rubber boot over the positive battery

terminal to help protect it from corrosion.

NOTE: If the battery is put into service after the date shown

on top/side of battery, charge the battery as instructed in the



the tractor.

4. Install lanyard using existing self-tapping screw. See Figure



Existing Self-

tapping Screw

Lanyard

Figure 1-4

NOTE: Insert self-tapping screw through hole in lanyard

and down into the same hole that it was removed from.

Position Drive Control levers

The drive control levers of the tractor are lowered for shipping

purposes. Using the hardware found in the manual bag, the

control levers must be repositioned to operate the tractor. To

reposition the control levers for operation, proceed as follows:

 Lift and swing the control levers up into the operating position.

2. From the outside, insert the bolts through the hourglass

spacers and the holes of the pivot bracket. Secure with the



Hourglass

Spacer

Nut

Bolt

Figure 1-5

 

Maintenance & Adjustments section for instructions on the

final adjustment of the levers.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Cub Cadet 54-inch Betreibershandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Rasenmäher Cub Cadet 54-inch