Cub Cadet GTX1054 Betreibershandbuch PDF herunterladen (Seite 25)

Cutting Deck Removal

To remove the cutting deck, proceed as follows:

 

position and engage the parking brake.

2. Lower the deck by moving the deck lift lever into the

bottom notch on the right fender.

 



4. Remove the belt guard and belt as follows Refer to Figure



a. Remove the hex screws.

b. Pull the belt keeper rod to the right and down to

remove.

c. 



Belt Keeper

Rod

Figure 7-1

NOTE: If there is too much tension on the belt for it to be



a ⁄ drive ratchet wrench (set to loosen) into the square

hole found in the left-hand deck idler bracket and pivot it



See Figure 7-2.

WARNING! Avoid pinching injuries. Never place

your fingers on the idler spring or between the belt

and a pulley while removing the belt.

Belt Guard

Figure 7-2

5. Looking at the cutting deck from the left side of the tractor,

locate the deck support pin on the rear left side of the

deck.

Se rvi ce

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Keine Kommentare

Cub Cadet GTX1054 Betreibershandbuch Seite 25