Cub Cadet 1238 Betreibershandbuch PDF herunterladen (Seite 17)

17Section 6 — Maintenance & adjuStMentS

Figure 6-3

4. Apply a light coating of Regular Grade Anti-Seize to the hex

shaft. See Figure 6-4.

NOTE: When lubricating the hex shaft, be careful not to get

any anti-seize on the aluminum drive plate or the rubber

friction wheel. Doing so will hinder the snow thrower’s

drive system. Wipe off any excess.

Figure 6-4

Adjustments

Shift Cable

If the full range of speeds (forward and reverse) cannot be

achieved, adjust the shift cable as follows:

1. Place the shift lever in the fastest forward speed position.

2. Loosen the hex nut on the shift cable index bracket. See

Figure 6-5.

Figure 6-5

3. Pivot the bracket downward to take up slack in the cable.

4. Retighten the hex nut.

5. If further adjustment is necessary move the shift cable to

one of the alternate holes in the shift cable index bracket.

Auger Control

Refer to the Assembly and Set-up section for instructions on

adjusting the auger control cable.

Skid Shoes

Refer to the Assembly and Set-up section for instructions on

adjusting the skid shoes.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Keine Kommentare

Cub Cadet 1238 Betreibershandbuch Seite 17