Cub Cadet CLT-538 Betreibershandbuch PDF herunterladen (Seite 22)

All belts on your tractor are subject to wear and should

be replaced if any signs of wear are present.

IMPORTANT:

The V-belts found on your tractor are

specially designed to engage and disengage safely. A

substitute (non-OEM) V-belt can be dangerous by not

disengaging completely. For a proper working machine,

use factory approved belts.

To change or replace the deck belt on your tractor,

proceed as follows:

• Lower the deck by moving the deck lift lever into the

bottom notch on the right fender.

• Remove the belt guards by removing the self-

tapping screws that fasten them to the deck.

• Remove the belt keeper rod from around the

engine pulley.

• Insert a 3/8”-drive ratchet wrench (set to loosen)

into the square hole found in the idler bracket on

the left side of the deck’s surface. See Figure 19.

• Grasp the ratchet’s handle and pivot it toward the

front of the tractor to relieve tension on the belt.

• With belt tension relieved, carefully remove the

belt from around the left-hand spindle pulley.

Figure 19

IMPORTANT:

Carefully allow the ratchet to pivot

rearward before removing it from the square hole.

• Remove the deck belt from around all pulleys,

including the deck idler pulley.

• Route the new belts (deck belt first).

• Remount the belt guards removed earlier.

Figure 20

3/8” Square Hole

Idler Bracket

Belt Guard

Right Hand Pulley

Deck Idler Pulleys

(beneath belt guard)

Engine Pulley

Idler Bracket

Left Hand Pulley

(beneath belt guard)

1 2 ... 17 18 19 20 21 22 23 24 25

Keine Kommentare

Cub Cadet CLT-538 Betreibershandbuch Seite 22