Cub Cadet CC98 Betreibershandbuch PDF herunterladen (Seite 8)

Assembly & Set-Up

Contents of Carton

One Lawn Mower• One Grass Catcher• One Grass Catcher Adapter•

One Side Discharge Chute• One Hardware Pack• One Bottle of Oil•

One Lawn Mower Operator’s Manual•

Assembly

NOTE: This unit is shipped without gasoline or oil in the engine.

Fill up gasoline and oil as instructed in the accompanying engine

manual BEFORE operating your mower.

Handle

Remove any packing material which may be between 1.

upper and lower handles.

Pull up and back on upper handle as shown in Fig. a.

3-1. Make certain the lower handle is seated securely

into the handle mounting brackets. Do not crimp

cables while lifting the handle up.

Tighten star knobs to secure upper handle to lower b.

handle. Make sure that each carriage bolt is seated

properly in the handle.

Figure 3-1

Locate the hairpin clip on the weld pin on each side of 2.

lower handle.

Remove hairpin clip from this hole. Using a pair of a.

pliers, insert hairpin clip into the hole on pin closest

to the bracket. See Fig. 3-2. Repeat on other side.

Insert a carriage bolt from the hardware pack into b.

the upper hole on the handle mounting bracket.

Secure with one plastic wing nut, also included

in the hardware pack. Repeat on other side with

remaining items from hardware pack.

NOTE: Make certain the drive cable is routed around the

outside and above the lower handle so it does not interfere

with attaching the grass bag. The chute door has been

designed to move the starter rope out of the way of the

bag when the chute door is opened.

The rope guide, which is connected to the support rod, is 3.

located on the right side of the lower handle. See Fig. 3-3.

Figure 3-2

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Keine Kommentare

Cub Cadet CC98 Betreibershandbuch Seite 8