Cub Cadet SLTX 1054 Betreibershandbuch PDF herunterladen (Seite 27)

Fuse

WARNING! Before servicing, repairing, or



brake, stop engine and remove key to prevent

unintended starting.





excessive amperage.



will not crank, first check to be certain that the fuse has not

blown. It is located under the hood, mounted behind the top of

the dash panel on the support bar.

CAUTION: Always use a replacement fuse with the

same amperage capacity as the blown fuse.

Tires

WARNING! Never exceed the maximum inflation

pressure shown on the sidewall of the tire.







maximum psi. Do not overinflate.

Uneven tire pressure could cause the cutting deck to mow

unevenly.

Changing the Transmission Drive Belt

Several components must be removed and special tools used in



Cub Cadet dealer to have the transmission drive belt replaced.

Changing the Deck Belt

WARNING! Shut the engine off and remove

ignition key before removing the cutting blade(s) for



using heavy gloves when grasping blades and

pulleys.

WARNING! The V-belts found on your tractor are

specially designed to engage and disengage safely.



not disengaging completely. For a proper working

machine, use factory approved belts.

All belts on your tractor are subject to wear and should be

replaced if any signs of wear are present . To change or replace

the deck belt on your tractor, proceed as follows:

Remove the deck as instructed on page 24.

Remove the belt guards by removing the hex screws that 2.

fasten them to the deck. See Fig. 7-7.

Loosen, but do not remove the belt keeper rod on the 

pulley located near the back of the deck. See Fig. 7-7

Carefully remove the deck belt from around the three 4.

spindle pulleys and the two deck idler pulleys.

Belt Guards

Hex Screws

Deck Idler Pulley

Belt Keeper Rod

Figure 7-7

27se c t i O n 7 — se r v i c e

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Cub Cadet SLTX 1054 Betreibershandbuch Seite 27

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Rasenmäher Cub Cadet SLTX 1054