Cub Cadet 721E Betreibershandbuch

Single StageSnow ThrowerModel 721EPRINTED IN U.S.A.Operator’s ManualFORM NO. 7/11/01IMPORTANT: Read safety rules and instructions carefully before ope

10SECTION 6: MAINTAINING YOUR SNOW THROWERReplacing Belt• Remove the belt cover by removing five hex screws. See Figure 12.Figure 12• Pull up on the

11SECTION 7: OFF-SEASON STORAGE• Clean snow thrower thoroughly.• Lubricate as instructed above with a light oil.• Follow “Storage” instructions in th

12SECTION 9: PARTS LIST FOR MODEL 721E159216621621420162414172338221013212560718111119125552627282930313233343536373839403341424344454647484950424951

13Model 721ERef. No. Part No. Part Description1.684-0174 Upper Chute Crank Assemby2.684-0177 Lower Chute Crank Assembly3.684-0178 Bracket Assembly: Mi

14Model 721ERef. No. Part No. Description1.629-0236 Extension Cord2.710-0157 Hex Bolt 5/16-24 x 0.75”3.710-0409 Hex Bolt 5/16-24 x 1.75”4.710-0502A T

15Model 721ERef. No. Part No. Description1.710-0487 Carriage Screw 5/16-18 x 2.0”2.710-1270 Machine Screw3.712-0324 Hex Lock Nut 1/4-204.720-0284 Han

MANUFACTURER’S LIMITED WARRANTY FOR:TWO-YEAR RESIDENTIALONE-YEAR COMMERCIALProper maintenance of your Cub Cadet equipment is the owner’s responsibilit

2TABLE OF CONTENTSContent PageImportant Safe Operation Practices ... 3A

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESDANGER: This machine was built to be operated according to the rules for safe operation in this manual.

44. Never operate with a missing or damaged discharge chute. Keep all safety devices in place and working.5. Never run an engine indoors or in a poorl

5SECTION 2: ASSEMBLING YOUR SNOW THROWERUnpacking From Carton• Cut along corners of the carton and lay it down flat. Remove packing material. • Remov

6handle. Hold the “Z” fitting with the pliers, not the cable, to avoid damaging the cable.NOTE: The upper hole in the control handle providesfor adjus

7Discharge Chute The angle of the discharge chute controls the distance that the snow is thrown. Tilt the discharge chute up for greater distance; til

8• If you have a grounded three-prong receptacle, proceed as follows. • Rotate choke lever to FULL position.• Connect power cord to switch box on dash

9SECTION 5: MAKING ADJUSTMENTSShave Plate • To check the adjustment of the shave plate, place the unit on a level surface. See Figure 8. The wheels,