Cub Cadet SW10530 Betreibershandbuch

Safety • Assembly • Operation • Adjustments • Maintenance • Troubleshooting • Parts Lists • Warranty60 Ottawa Street South, KITCHENER, ONTARIO N2G 4J

104Operating Your Snow ThrowerNow that you have set up your snow thrower for opera-tion, get acquainted with its controls and features. These are desc

114Operating Your Snow ThrowerWARNINGThe operation of any snow thrower can result in foreign objects being thrown into the eyes, which can damage your

12Gas & Oil Fill-Up Service the engine with gasoline and oil as instructed in the separate engine manual packed with your unit. Read instructions

13NOTE: Keep the key in a safe place. The engine cannot start without the ignition key.Recoil Starter1. With engine running, pull starter rope with a

14Shift CableIf the full range of speeds (forward and reverse) cannot be achieved, refer to the figure to the left and adjust the shift cable as follo

1552. With the drive control released, there must be 1/8” clearance between the friction wheel and the drive pulley in all positions of the shift lev

166Maintaining Your Snow ThrowerWARNINGAlways stop engine, disconnect spark plug, and ground against engine before cleaning, lubricating or performing

176Maintaining Your Snow ThrowerNOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils al

186Maintaining Your Snow ThrowerWARNINGAlways stop engine, disconnect spark plug, and ground against engine before cleaning, lubricating or doing any

196Maintaining Your Snow ThrowerFriction Wheel RemovalIf the snow thrower fails to drive with the drive control engaged, and performing the drive cont

2Finding and Recording Model NumberTable of ContentsBEFORE YOU START ASSEMBLING YOUR NEW EQUIPMENT, please locate the model plate on the equipment an

207Off-Season StorageNever store snow thrower with fuel in tank indoors or in poorly ventilated areas, where fuel fumes may reach an open flame, spark

21NOTE: This section addresses minor service issues. For further details, contact customer assistance. 8Trouble- ShootingCauseProblem RemedyEngine fai

22TWO YEAR SUPREME WARRANTY:For two years from date of retail purchase within Canada, MTD PRODUCTS LIMITED will, at its option, repair or replace, for

31Safety LabelsWARNINGThis symbol points out important safety instructions which, if not followed, could endanger the per-sonal safety and/or propert

42Safe Operation PracticesTraining1. Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble

5Operation1. Do not put hands or feet near rotating parts, in the auger/impeller housing or chute assembly. Contact with the rotating parts can amput

63Setting Up Your Snow ThrowerIMPORTANT: The snow thrower is shipped with oil and WITHOUT GASOLINE. After assembly, refer to separate engine manual fo

7Figure 43Figure 5Figure 64. Finish securing chute control assembly to chute support bracket with wing nut and hex screw removed earlier. See Figure

83Setting Up Your Snow ThrowerFigure 8Figure 7Drift Cutters (If Equipped)Drift cutters should be used when operating the snow thrower in heavy drift c

9Figure 10A3Setting Up Your Snow ThrowerWARNINGNever use your hands to clean snow and ice from the chute assembly or auger housing.IMPORTANTUnder any